Pennsylvania Code & Bulletin
COMMONWEALTH OF PENNSYLVANIA

• No statutes or acts will be found at this website.

The Pennsylvania Bulletin website includes the following: Rulemakings by State agencies; Proposed Rulemakings by State agencies; State agency notices; the Governor’s Proclamations and Executive Orders; Actions by the General Assembly; and Statewide and local court rules.

PA Bulletin, Doc. No. 98-1231

RULES AND REGULATIONS

Title 67--TRANSPORTATION

DEPARTMENT OF TRANSPORTATION

[67 PA. CODE CH. 105]

Mechanical, Electrical and Electronic Speed-Timing Devices

[28 Pa.B. 3588]

   The Department of Transportation (Department), Bureau of Motor Vehicles (Bureau), by this order adopts an amendment to Chapter 105 (relating to mechanical, electrical and electronic speed-timing devices) to read as set forth in Annex A.

   Notice of proposed rulemaking was published at 27 Pa.B. 1821 (April 12, 1997) with an invitation to submit written comments within 30 days of publication. No comments were received by the Department.

Purpose of this Chapter

   The purpose of this chapter is to provide rules concerning the calibrating and testing of mechanical, electrical and electronic speed-timing devices by stations appointed by the Department.

Purpose of the Amendment

   The purpose of the amendment is to prescribe the method for calibrating and testing electronic devices (radar) which operate in the Ka-Band frequency to assure their accuracy under 75 Pa.C.S. § 3368 (relating to speed timing devices). Historically, the Department does not identify electronic devices (radar) by name in the regulations, but only the method of calibration for particular frequencies and that once the calibration method is approved in the regulations, the Department will list specific electronic devices (radar), by name, in its annual publication in the Pennsylvania Bulletin of approved devices and speed-timing calibration stations.

   The most significant amendment to this regulation is the inclusion of the test frequencies for calibrating and testing Ka-Band electronic devices (radar) in § 105.15(a)(3)(iii), (5)(v) and (7)(iii) (relating to calibration).

Additional Modifications to the Proposed Rulemaking

   The final-form text of the regulation contains modifications none of which enlarge the scope of this regulation as originally proposed, and thus may be published as final rulemaking. The following represents a summary of the modifications:

   Sections 105.15(a)(3)(iii) and (7)(iii) both contain printing errors. In § 105.15(a)(3)(iii) (relating to calibration and the stability test), the last sentence of subparagraph (iii) directs the person doing the calibrating to adjust the frequency of function generator, while observing the frequency counter, to one of three possible bands. This sentence was incorrectly published at 27 Pa.B. 1822, to read as follows: ''While observing the frequency counter, adjust frequency of function generator to 1726 Hz (X-Band) [or], § 3961 Hz (K-Band) or 5692 Hz (Ka-Band).'' The section symbol before 3961 Hz must be eliminated and the sentence should have read as follows: ''While observing the frequency counter, adjust the frequency of function generator to 1726 Hz (X-Band) or 3961 Hz (K-Band) or 5692 Hz (Ka-Band).'' Further for clarity and consistency, the Department has deleted, from both the proposed § 105.15(a)(3)(iii) and (7)(iii), the commas within the series since the word ''or'' eliminates the need for the use of the commas. In § 105.15(a)(7)(iii) subparagraph (iii) directs the person doing the calibrating to activate the four watt signal source, modulated to 100% for one of three bands. This sentence was incorrectly published in 27 Pa.B. 1822, to read as follows: ''Activate the 4 watt signal source, modulated at 100%, 1726 Hz (X-Band) or 3961 Hz (K-Band) [or], § 5692 Hz (Ka-Band).'' The section symbol before 5692 Hz must be eliminated. Further for clarity, the Department desires that the subparagraph be printed as originally submitted, that is, with the word ''or'' appearing after each band. Accordingly, the sentence should have read as follows: ''Activate the 4 watt signal source, modulated at 100%, 1796 Hz (X-Band) or 3961 Hz (K-Band) or 5692 Hz (Ka-Band).''

Persons and Entities Affected

   This final-form regulation affects drivers of motor vehicles, stations which calibrate and test speed-timing devices and the State Police.

Fiscal Impact

   This final-form regulation will not impose any increased cost on private persons, speed-timing device calibration and testing stations, or State or local governments. The State Police may incur cost if it elects to purchase an electronic device (radar) which operates in the Ka-Band frequency. There are a few manufacturers that make an electronic device (radar) which operates in the Ka-Band frequency. The cost of one device tested and approved for accuracy by the State Police is priced at approximately $1,385.

   This final-form regulation will not occasion the development of any additional reports or other paperwork requirements.

Regulatory Review

   Under section 5(a) of the Regulatory Review Act (71 P. S. § 745.5(a)), on March 31, 1997, the Department submitted a copy of the notice of proposed rulemaking, published at 27 Pa.B. 1821, to the Independent Regulatory Review Commission (IRRC) and the Chairpersons of the House and Senate Transportation Committees.

   This final-form regulation was deemed approved by the Committees on July 6, 1998. The amendment was deemed approved by IRRC July 9, 1998, in accordance with section 5(g) of the Regulatory Review Act.

Sunset Provisions

   The Department is not establishing a sunset date for this regulation, since this regulation is needed to administer provisions required under 75 Pa.C.S. §§ 3368 and 6103 (relating to speed timing devices; and promulgation of rules and regulations by department). This regulation will be continuously monitored for its effectiveness by the Department and the State Police.

Contact Person

   The contact person is Barb Tomassini, Bureau of Motor Vehicles, Vehicle Inspection Division, Third Floor, Riverfront Office Center, 1101 South Front Street, Harrisburg, PA 17104, (717) 787-2895.

Authority

   This final-form regulation is amended under the authority contained in 75 Pa.C.S. §§ 3368 and 6103.

Findings

   The Department finds that:

   (1)  Public notice of intention to amend the administrative regulation amended by this order has been given under sections 201 and 202 of the act of July 31, 1968 (P. L. 769, No. 240) (45 P. S. §§ 1201 and 1202) and the regulations promulgated thereunder, 1 Pa. Code §§ 7.1 and 7.2.

   (2)  The amendment of the regulation of the Department in the manner provided in this order is necessary and appropriate for the administration and enforcement of the authorizing statutes.

Order

   The Department, acting under the authorizing statutes, orders that:

   (a)  The regulations of the Department, 67 Pa. Code Chapter 105, are amended by amending § 105.15 to read as set forth in Annex A with ellipses referring to the existing text of the regulation.

   (b)  The Secretary of the Department shall submit this order, and Annex A to the Office of Attorney General and the Office of General Counsel for approval as to legality, as required by law.

   (c)  The Secretary of the Department shall certify this order, and Annex A, and deposit them with the Legislative Reference Bureau, as required by law.

   (d)  This order shall take effect upon publication in the Pennsylvania Bulletin.

BRADLEY MALLORY,   
Secretary

   Fiscal Note: Fiscal Note 18-340 remains valid for the final adoption of the subject regulation.

   (Editor's Note: For the text of the order of the Independent Regulatory Review Commission relating to this document, see 28 Pa.B. 3558 (July 25, 1998).)

Annex A

TITLE 67.  TRANSPORTATION

PART I.  DEPARTMENT OF TRANSPORTATION

Subpart A.  VEHICLE CODE PROVISIONS

ARTICLE VI.  OPERATION OF VEHICLES

CHAPTER 105.  MECHANICAL, ELECTRICAL AND ELECTRONIC SPEED-TIMING DEVICES

Subchapter B.  ELECTRONIC DEVICES (RADAR)

§ 105.15.  Calibration and testing procedure.

   (a)  General. An electronic device shall be calibrated and tested as follows:

*      *      *      *      *

   (3)  Stability test. The stability test shall be conducted in the following manner:

*      *      *      *      *

   (iii)  Adjust square wave output of function generator to the switching level of the pin diode switch. While observing the frequency counter, adjust frequency of function generator to 1726 Hz (X-Band) or 3961 Hz (K-Band) or 5692 Hz (Ka-Band).

*      *      *      *      *

   (5)  Accuracy test. The accuracy test shall be conducted in the following manner:

*      *      *      *      *

   (v)  While observing the frequency counter, adjust the function generator to each test frequency. Note and record the speed indicated on the electronic device display. Each test frequency shall produce the correct speed in mph within the limits of +0, -1 mph.

Test Frequencies (in Hz)

Indicated Test
X BandK BandKa BandSpeed mph
628  1440207020
785  1801258825
942  2161310530
10992521362235
12562881414040
14123241465745
15693601517550
17263961569255
18834321621060
20404681672765
21975042724670
23545402776275
25115762828180
26686122879785
28256482931690
29826842983295
3139720210351100
3296756210867105
3453792211385110
3610828311902115
3767864312420120
3924900312937125
4081936313455130
4238972313972135
43941008314490140

*      *      *      *      *

   (7)  Rejection of extraneous RF fields.

*      *      *      *      *

   (iii)  Activate the 4 watt signal source, modulated at 100%, 1726 Hz (X-Band) or 3961 Hz (K-Band) or 5692 Hz (Ka-Band).

*      *      *      *      *

[Pa.B. Doc. No. 98-1231. Filed for public inspection July 31, 1998, 9:00 a.m.]



No part of the information on this site may be reproduced for profit or sold for profit.

This material has been drawn directly from the official Pennsylvania Bulletin full text database. Due to the limitations of HTML or differences in display capabilities of different browsers, this version may differ slightly from the official printed version.