25 Pa. Code § 130.373. Additional labeling requirements for aerosol adhesive, adhesive remover, electrical cleaner, electronic cleaner, energized electrical cleaner and contact adhesive products.

§ 130.373. Additional labeling requirements for aerosol adhesive, adhesive remover, electrical cleaner, electronic cleaner, energized electrical cleaner and contact adhesive products.

(a)  In addition to the requirements specified in § §  130.371, 130.372, 130.391 and 130.392, both the manufacturer and responsible party for each aerosol adhesive, electrical cleaner, electronic cleaner, energized electrical cleaner and contact adhesive product subject to this subchapter shall ensure that all products clearly display the following information on each product container which is manufactured on or after the applicable effective date for the category specified in §  130.211 (relating to table of standards):
   (1)  The product category as specified in §  130.211 or an abbreviation of the category shall be displayed.
   (2)  The applicable VOC standard for the product that is specified in §  130.211, except for energized electrical cleaner products, expressed as a percentage by weight, shall be displayed unless the product is included in an alternative control plan approved by the Department, as provided in § §  130.451—130.465 (relating to ACP for consumer products).
   (3)  If the product is included in an alternative control plan approved by the Department, and the product exceeds the applicable VOC standard specified in §  130.211, the product shall be labeled with the term ‘‘ACP’’ or ‘‘ACP product.’’
   (4)  If the product is classified as a special purpose spray adhesive, the applicable substrate or application or an abbreviation of the substrate or application that qualifies the product as special purpose shall be displayed.
   (5)  If the manufacturer or responsible party uses an abbreviation as allowed by this section, an explanation of the abbreviation shall be filed with the Department before the abbreviation is used.
(b)  The information required in §  130.371(a) (relating to product dating requirements) shall be displayed on the product container so that it is readily observable without removing or disassembling a portion of the product container or packaging. For the purposes of this subsection, information may be displayed on the bottom of a container as long as it is clearly legible without removing product packaging.

Authority

   The provisions of this §  130.373 amended under section 5 of the Air Pollution Control Act (35 P. S. §  4005).

Source

   The provisions of this §  130.373 amended October 10, 2008, effective October 11, 2008, 38 Pa.B. 5598. Immediately preceding text appears at serial pages (291993) to (291994).

Cross References

   This section cited in 25 Pa. Code §  130.215 (relating to requirements for aerosol adhesives).

No part of the information on this site may be reproduced for profit or sold for profit.

This material has been drawn directly from the official Pennsylvania Code full text database. Due to the limitations of HTML or differences in display capabilities of different browsers, this version may differ slightly from the official printed version.