OPERATIONS
§ 77.571. Bench development.
The height of the working face on a bench shall be limited as follows:
(1) The maximum height of the working face of a bench in consolidated material—other than thin seam operation which will be returned to AOC—may not exceed 50 feet except as follows:
(i) If topography influences the height of the uppermost face, the highwall may be developed to 65 feet.
(ii) If geologic or safety considerations require the development of a lower working face height.
(2) The Department may grant a waiver to develop a greater height on the working face if a stability analysis shows the proposed face to be stable and the applicant demonstrates with clear and convincing evidence that there is no practical alternative to developing a greater height. The stability analysis shall be performed under § 77.573 (relating to stability analysis).
(3) The maximum height of the working face of a bench in unconsolidated material shall be 25 feet. The Department may grant a waiver to develop a greater height to the working face based on the type of equipment to be used and a field assessment by the Department on the stability of the face.
(4) The minimum width for a horizontal bench between successive working faces shall be 25 feet.
(5) The Department may impose lower working face heights on the working face if the working face is a potential threat to health or safety.
Source The provisions of this § 77.571 adopted March 16, 1990, effective March 17, 1990, 20 Pa.B. 1643.
Cross References This section cited in 25 Pa. Code § 77.573 (relating to stability analysis).
No part of the information on this site may be reproduced for profit or sold for profit.
This material has been drawn directly from the official Pennsylvania Code full text database. Due to the limitations of HTML or differences in display capabilities of different browsers, this version may differ slightly from the official printed version.
