Pennsylvania Code & Bulletin
COMMONWEALTH OF PENNSYLVANIA

• No statutes or acts will be found at this website.

The Pennsylvania Code website reflects the Pennsylvania Code changes effective through 54 Pa.B. 6234 (September 28, 2024).

7 Pa. Code § 101.3. Standards for grades of vealers.

§ 101.3. Standards for grades of vealers.

 The following minimum standards for grades of vealers are the same as the official United States Department of Agriculture standards, 7 CFR 53.123 (relating to specification for official United States standards for grades of vealers) and apply in this Commonwealth:

   (1)  Prime. Superior in conformation, quality and finish. In conformation, Prime vealers tend to be low-set, compact, short of neck and body and relatively thick-fleshed. They are wide over the back, loin and rump. Shoulders and hips are moderately neat and smoothly laid in. The twist is deep and full, and the rounds are thick and moderately plump. There is a slight fullness or plumpness evident over the crops, loin and rump, which contributes to a rather well-rounded appearance. Prime vealers have a thin fat covering over the crops, back, loin, rump and upper ribs. The brisket, rear flanks and cod or udder show distinct evidence of fullness. Prime vealers exhibit evidences of high quality. The bones tend to be proportionately small, joints smooth, the hide moderately thin and pliable, and the body very trim, smooth and symmetrical.

   (2)  Choice. Tend to be moderately low-set, short-necked and compact. They are slightly thick-fleshed and moderately wide over the back and loin. Shoulders and hips are usually moderately neat and smoothly laid in, with only a slight tendency toward prominence. The loin, rump and rounds may appear almost flat, with little evidence of fullness. Choice vealers have a very thin fat covering over the back, loin and upper ribs. The brisket, rear flanks and cod or udder may show a very slight fullness. Choice vealers usually present a moderately refined appearance.

   (3)  Good. Tend to be slightly compact and slightly wide of back and loin. The neck may be slightly long and thin. Good grade vealers tend to be slightly thin-fleshed, and the loin, rump and rounds are flat and may present a very slight sunken or hollowed-out appearance. The shoulders and hips are slightly prominent. The fat covering is very limited and is discernible only over portions of the back and loin. The brisket, rear flanks and cod or udder may have small fat deposits but have no apparent fullness. Good grade vealers are usually moderately smooth and slightly refined in appearance.

   (4)  Standard. Tend to be rangy, upstanding, long and thin of neck, narrow over the back, loin and rump, and shallow in the twist. They are thin-fleshed, and there is a distinctly sunken or hollowed-out appearance over the back, loin and rounds. Hips and shoulders appear moderately prominent. There is an extremely thin fat covering over portions of the back and loin that is difficult to detect in the live animal. The vealers may show the heavy bones, thick hide, prominent hips and shoulders associated with coarseness, or they may show the small bones, tight hide and angularity denoting over-refinement.

   (5)  Utility. May tend to be very rangy, angular and long and thin of neck. They are very thinly fleshed, narrow over the back, loin and rump, and shallow in the twist. Hips and shoulders are very prominent, and the crops, back, loin, rump and rounds present a very sunken or hollowed-out appearance. Utility vealers show no visible evidence of fat covering. Utility vealers tend to be of low quality. The bones and joints are usually proportionately large and the hide either thick or tight and inelastic.

   (6)  Cull. Typically appears to be extremely rangy, angular, long and thin-necked, narrow and shallow bodied. Shoulders and hips are extremely prominent, and the crops, back, loin, rump and rounds present an extremely sunken or hollowed-out appearance. The general appearance denotes low quality. The relative proportion of meat to bone is very low, joints appear large and coarse, and the body is very unsymmetrical.

Cross References

   This section cited in 7 Pa. Code §  101.2 (relating to applications of standards).



No part of the information on this site may be reproduced for profit or sold for profit.


This material has been drawn directly from the official Pennsylvania Code full text database. Due to the limitations of HTML or differences in display capabilities of different browsers, this version may differ slightly from the official printed version.